Detecting Adventures Stork Leg Shaft for Minelab Excalibur Metal Detector

Stork Carbon Fiber Shaft for Minelab Excalibur

• Glides through the water like you have never experienced.
• Light, strong and rigid
• Weights only 5 ounces
• Bolts (for maximum rigidity) directly to your Excalibur with the supplied Stainless screws, with our without the plastic knobs.
• Included is colored knob/screw which you might like.
• The lower tear drop shaped rubber washers are larger than the original Minelab. 2 spare washers are supplied incase you wear the original set out in a year or two.
• You should use your original coil screw and nut but we have included a spare nylon screw and wing nut just incase.
• Carbon Fiber Lower shaft
• A premium roll of 3M black tape is included so you can seal all holes and joints so sand will not enter and freeze up your shafts.
• “Stork Leg” Shaft will fit most handles that take a 3/4″ OD lower shaft.
• The lower shaft is 10mm diameter (just over 3/8″)
• 3 year warranty if you seal all holes and joints with black electrical tape (supplied) so sand will stay out of the joints.
• MADE IN THE USA