Detecting Adventures Stork Leg Shaft for Minelab Excalibur Metal Detector

|
SL-002
$95.00 $128.25( / )
Shipping calculated at checkout.
Detecting Adventures Stork Leg Shaft for Minelab Excalibur Metal Detector Stork Carbon Fiber Shaft for Minelab Excalibur Glides through the water like you have never experienced. Light, strong and rigid Weighs only 5 ounces Bolts (for maximum rigidity) directly to your Excalibur with the supplied Stainless screws, with or without...
Add to Wishlist
Real time +12 visitor right now

Detecting Adventures Stork Leg Shaft for Minelab Excalibur Metal Detector

Stork Carbon Fiber Shaft for Minelab Excalibur

  • Glides through the water like you have never experienced.
  • Light, strong and rigid
  • Weighs only 5 ounces
  • Bolts (for maximum rigidity) directly to your Excalibur with the supplied Stainless screws, with or without the plastic knobs.
  • Included is a colored knob/screw.
  • The lower tear drop-shaped rubber washers are larger than the original Minelab. 2 spare washers are supplied in case you wear the original set out in a year or two.
  • You should use your original coil screw and nut but we have included a spare nylon screw and wing nut just in case.
  • Carbon Fiber Lower shaft
  • A premium roll of 3M black tape is included so you can seal all holes and joints so sand will not enter and freeze up your shafts.
  • "Stork Leg" Shaft will fit most handles that take a 3/4" OD lower shaft.
  • The lower shaft is 10mm in diameter (just over 3/8")
  • 3-year warranty if you seal all holes and joints with black electrical tape (supplied) so sand will stay out of the joints.
  • MADE IN THE USA
Type: 

Metal Detecting Parts & Accessories

Vendor: 

Detecting Adventure

SKU: 

SL-002

Weight: 

0.94 lb

Recently viewed